Single-stage double-suction centrifugal pumps
Release time:
2025-10-27
Author:
Source:
Split-Case Pumps, also known as single-stage double-suction centrifugal pumps, occupy a significant share of the water pump market and are widely recognized units. They are extensively used in critical sectors such as iron and steel, petrochemicals, municipal water services, and power generation.
These pumps are favored by users due to their advantages, including high flow capacity, stable operation, excellent performance, and high efficiency. However, many users discover that even after selecting a high-quality split-case pump suited to their operating conditions, its efficiency often fails to meet expectations after a period of use. The reasons for this are varied.
Firstly, water quality plays a role. Even when conveying clean water, scale can gradually build up inside the pump casing, and corrosion can occur. Just as clean water transported through water supply pipes can eventually erode them over time, the same is true for water conveyed by pumps. Scale and corrosion create roughness on the internal pump surfaces, reducing the pump's effective volume, decreasing its pumping capacity, increasing head loss, and consequently lowering both volumetric and hydraulic efficiency.
The erosive effect of water flow is another significant factor. While water may seem gentle, when imbued with kinetic energy its force becomes substantial. Over time, it can even wear away rock. Similarly, the internal surfaces of the pump passages and the impeller's water-contact areas can be eroded by the flow, becoming rough. This increases the friction coefficient and reduces hydraulic efficiency.
Pump cavitation is also a major contributor to efficiency loss. During operation, negative pressure can form on the back side of the impeller vanes, leading to the formation of vapor pockets and a honeycombed surface texture. Combined with electrochemical corrosion, this causes impeller cavitation. While measures can be taken to slow its onset and mitigate its impact, cavitation cannot be entirely avoided. Therefore, some efficiency decrease after prolonged operation is inevitable. Furthermore, mechanical wear leads to increased clearances (causing leakage losses) and frictional resistance, gradually increasing volumetric and mechanical losses and thus reducing both volumetric and mechanical efficiency.
The factors mentioned above represent the inherent, unavoidable efficiency degradation that occurs simply due to the passage of time in pump operation, typically leading to an efficiency reduction of approximately 2% to 5%. However, if a significant efficiency drop is observed in a new pump, or if the efficiency loss in any pump is excessive, it should be investigated as a potential pump malfunction.
Recommended Reading